Updating the wiikey gridview1rowupdating event not firing
In opposite to what's stated in the official specification, some people reported problems with Gamecube games that are using streaming audio. You do not have to upgrade the firmware, as the Wiikey comes shipped with one.The problems seem to happen with any kind of media, be it backup or orignal. What you should (and in the case of clones have to) do though, is use the "Setup Disc Images v1.3" (available via download) to configure your chip to play games in the right video format etc.
In contrast to that, there are little to no complains about clones not working.My chip installation is fine and the firmware update went without a hitch (as did 1.9b some time ago). – Yes Percentage of Backups that load – 0% (all show as unknown, the disc just stops spinning. Press the Eject Button and remove the disc.” error) Originals load? – Yes, does nothing Tried Config/Update Discs/GCOS boot?So, if you have a similar problem, post your experience here! Description – A couple of days after updating to 1.9g and playing SMG (Euro version on Euro console), all backups stopped to work. I think it might have happened when the Wii was disconnected from the mains (not 100% sure). – Yes, none will get recognized, same as all backups Media Tried – Sony /-R, Verbatim -R, Fujifilm -R, Imation R, TDK -R, @2x and 4x Burner(s) – Nero, Imgburn Black Magic – Tried: Taking out CMOS battery and unplug off mains for a while, formatting Wii system memory I’d also like to see a description of what happens when you use the recovery disc successfully.To determine if a Wiikey is a clone use the following guide: As of now, all region free methods (be it patching with a region free application, or in this case, the Wiikey's built in region free capability) share the same method of patching.
Therefore, all compatibility issues are the same, and can be documented on one specific page. The Wii Key modifies the responses that the DVD Drive sends to the motherboard when verifying discs authenticity.This update also makes some improvements to the alignment of the selection menu cursor.